This webpage can automatically do the preparation of the .ini file as described in the installation instructions for my FFCP PrusaSlicer config bundle.
What this does, is updating all lines starting with “
post_process =” with the
PATH value, after inserting the correct escape characters. You can use this tool in any scenario where you need to change the post-processing script to the same path for all print settings in an exported config bundle.
If the “240°C” checkbox is not enabled, the script will also cap all temperatures in the ini file to 240°C, to avoid frying PTFE liners in stock extruders. You will not have optimal results with certain materials in this case, and you should not even attempt to print polycarbonate. If you have upgraded to all-metal hot-ends, enable this checkbox to preserve the higher temperatures in the config.
This all runs within your browser and assumes you are using a relatively modern browser. If you are using some antique version of IE, it will likely not work.
Providing the download of the modified file works by the grace of FileSaver.js.